I want to know what others think about the workflow to generate cross sections and designing for road reconstruction projects using Civil3D. Since I am not an expert in Civil3D, many times all I want to do is generate a road alignment showing the road edges. Is there an easier way to do this than creating assemblies and corridors? More like what Road CEM from Transoft does?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Road Design Software
- Thread starter Spazax5
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question
- Locked
- Question
