I'm trying to draw a cantilevered beam in RISAFloor off the side of a column (There's no back-span, just a small beam cantilevered off one side of the column). I get an error when I try to draw it saying that the point at the free end is unsupported...even if the end releases of the beam are fixed. Is there anyway to do this in RISAFloor?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
RISAFloor - Cantilevered Beam
- Thread starter SixkHz
- Start date
JoshPlumSE
Structural
There is not currently a way to do this in RISAFloor. At least not without first bringing the model into RISA-3D and then modeling that portion of the floor system there.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question