Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Results listing

Status
Not open for further replies.

slava74

Electrical
Joined
Sep 9, 2002
Messages
19
Location
US
How I can get the COMPLETE SET of the nodal results in Emag3D? The problem is that I used PRNSOL, PRESOL, PRNSL, PRVECT and many other ways to get the results in approx. 120.000 nodes in 3D problem. I've never got more than 18.000 nodes in *.lis files. Thanks.
 
Did you try putting your results in a parameter (*vget) and writing it to a standard FORTRAN File (*vwrite) ?

Nicolas
 
I used to have the same problem. After doing the ouput you have to close the file, otherwise only a partial output is done. I don't remember the command, but if you go check the help file for the output command you will see what I mean.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top