Oct 21, 2004 #1 FranciscoG Mechanical Joined Oct 25, 2002 Messages 13 Location CL what are the requirements of pipeline design: elbows, tees, etc for running intelligent pigs?
Oct 21, 2004 #2 jsummerfield Electrical Joined Jan 26, 2003 Messages 671 Location US Consult the smart pig manufacturer regarding the launcher/receiver lenghts, turning radii, etc. The lengths and other requirements are not uniform. John Upvote 0 Downvote
Consult the smart pig manufacturer regarding the launcher/receiver lenghts, turning radii, etc. The lengths and other requirements are not uniform. John
Oct 21, 2004 #3 TD2K Chemical Joined Jan 11, 2002 Messages 2,629 Location US I saw one recent ad where they claimed they could run their pigs (and they were smart pigs) through 1.5 bends. Some of the older models required quite a larger radius bends so as suggested, talk to the various vendors. Upvote 0 Downvote
I saw one recent ad where they claimed they could run their pigs (and they were smart pigs) through 1.5 bends. Some of the older models required quite a larger radius bends so as suggested, talk to the various vendors.
Oct 22, 2004 #4 davefitz Mechanical Joined Jan 27, 2003 Messages 2,927 Location US see the sponsors and tech papers at last week's Int'l pipeline conf at Calgary for latest smart pigs- at <http://www.internationalpipelineconference.com> Upvote 0 Downvote
see the sponsors and tech papers at last week's Int'l pipeline conf at Calgary for latest smart pigs- at <http://www.internationalpipelineconference.com>