Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Request plastic portion of principal strains

Status
Not open for further replies.
SiggiN

SiggiN

Marine/Ocean
Joined
Mar 18, 2019
Messages
33
Location
NO
Hi!

Is it possible to output only the plastic portion of the principal strains in Autodesk Nastran?

If I've understood correctly these results are relevant when checking Local Failure Criteria acc. BPVC 2/3

My workaround so far has been to subtract the proportional limit strain from the principal strains, however i'm not sure if this would be valid if I have load reversals? Thoughts?

Thank you!

Regards
Siggi
 
Status
Not open for further replies.

Similar threads

EKCP
  • Question Question
TABLES1 limited number of stress/strain entries for SOL 401 Using FEMAP 24.06
Replies
6
Views
15K
rb1957
rb1957
ghylander
  • Locked
  • Question Question
Use of MFLUID for external fluid field
Replies
0
Views
1K
ghylander
ghylander
Itxusta
  • Locked
  • Question Question
2d axisymmetric analysis of a revolution part
Replies
3
Views
1K
Itxusta
Itxusta
flyforever85
  • Locked
  • Question Question
Request plastic strain in NASTRAN
Replies
2
Views
464
flyforever85
flyforever85
Gabrieldondeu
  • Locked
  • Question Question
Freq response (SOL 111) of a composite model on Nastran: no stress calculated in pcomp elements
Replies
1
Views
687
dmapguru
dmapguru

Part and Inventory Search

Sponsor

Back
Top