Request for documents or assistance on mechanical design of conical shaft section in centrifugal pumps

[sofia-safi]

Hello everyone,


I am currently looking for detailed technical documents or studies on the mechanical dimensioning of the conical section of the rotating shaft in centrifugal pumps. Specifically, I need resources explaining the calculation steps, design criteria, as well as the specifications and tolerances applied to this critical part.


If anyone has access to such documents or can point me toward reliable references (articles, reports, theses), I would greatly appreciate your support.


Thank you in advance for your help and expertise!


Best regards,

 

[Artisi]

What do you mean "conical section"?

 

[goutam_freelance]

Please check
https://www.engineersedge.com/hardware/tapered_shaft_end_and_mating_hole_design_15009.htm

For the design, since this shaft is very specialized, the suppliers should be consulted. One such supplier is given below:

Parker Hannifin Corp., Hydraulic Pump Div., 14249 Industrial Pkwy., Marysville, OH 43040, (937) 644-3915, www.parker.com