Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Render sets NX 11

Status
Not open for further replies.

venomex

Automotive
Joined
Jan 12, 2015
Messages
92
Location
IN
Where do I find the render sets option to apply for a view in NX 11?

I can create groups and add parts to it in settings, but when I go into settings of a view and general tab I don't see render sets option like in NX 10

Pratham,
Using NX 11.0.0.33
 
For the view, Settings, Common -> General -> Render Sets group -> Define in View (see image below).

2017-02-08_15-17-53_cwuiin.png



Anthony Galante
Senior Support Engineer


NX3 to NX11 with almost every MR (24versions)
 
Strange, I just tried it out in another assembly drawing and it showed the option like you showed.
But in another drawing( for which I posed the query) I don't see it.
Attached image of settings box.
1_tqpsyf.jpg


Pratham,
Using NX 11
 
Is it hidden because it is collapsed (see attached video).

Link


Anthony Galante
Senior Support Engineer


NX3 to NX11 with almost every MR (24versions)
 
Thanks Anthony...That solved it...I had to expand the settings from collapsed....
Again thank you very much...but I wonder why when I created another sample/test drawing to check the render sets option, it was in expanded state but collapsed in the other drawing...
Aren't they supposed to be in the same/ last used settings/state?

Pratham,
Using NX 11
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top