Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Refile utility 1
- Thread starter Gabriel45
- Start date
Are you running native NX (no PDM/PLM), Teamcenter, or some other PDM/PLM?
I ask because there are different versions of the refile utility for native and TC.
www.nxjournaling.com
I ask because there are different versions of the refile utility for native and TC.
www.nxjournaling.com
-
1
- #4
When you open a file from an older version there are some conversions that NX does behind the scenes. This causes the older version files to open slower than current version files. The refile utility lets you batch these conversions off-hours so you don't need to manually spend the time opening and saving files. One recent version of the refile utility did some other stuff that simply opening the file and saving didn't do; I think it had to do with the lightweight body management stuff, I don't remember the details right now.
The refile utility is more important in a Teamcenter environment because once a file has a release status, it cannot be saved by the average user. Now you have a conversion delay every time you open a file, multiplied by the number of users; the wasted time can add up...
www.nxjournaling.com
The refile utility is more important in a Teamcenter environment because once a file has a release status, it cannot be saved by the average user. Now you have a conversion delay every time you open a file, multiplied by the number of users; the wasted time can add up...
www.nxjournaling.com
Typically I only ran refile on my hardware library parts as normal users could not modify them. It prevents the parts from being flagged as 'modified' as they have already been updated to the latest version of NX.
I suspect you are having issues with your template parts and those can either be opened and resaved or run the refile utility against them. Look in the UGII directory for refile.exe. If you open a UG command prompt and type refile, it should list the options for the command.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
I suspect you are having issues with your template parts and those can either be opened and resaved or run the refile utility against them. Look in the UGII directory for refile.exe. If you open a UG command prompt and type refile, it should list the options for the command.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
- Thread starter
- #6
We are running UG/NX through Teamcenter, the main problem is opening existing files and doing a save as to a new item or a new revision, this however is not consistant on some files it works fine on others it hangs up. It just shows the windows icon spinning but nothing happens, and we end up having to use ctl-alt-del to open task manager and it shows "NX not responding", so we kill that session and then we have to do the same with Teamcenter. We then reboot our system and when you open that component, it shows that a dataset was created but there is nothing there.
- Status