Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reference Dimension

Status
Not open for further replies.

Recon1775

Aerospace
Joined
Jul 24, 2002
Messages
137
Location
US
I haven't used AutoCad for a few years and I remember when drawing lines or any feature there used to be a dimension that would show referencing a endpoint or any reference near by as you draw the feature. I'm currently using AutoCad LT 2004... I'm I losing my mind or is there something like this?
 
Not sure about LT but could you be referring to OSNAP or maybe OTRACK? At the bottom of the AutoCAD screen are a series of buttons that you can toggle on. OSNAP and OTRACK are two of them. Does LT have this?

"Everybody is ignorant, only on different subjects." — Will Rogers
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top