Referance sets

[flitch1969]

When i create features they get added to the referance sets. i would prefer to add them myself. Where is the setting to stop this from happening?

thanks

 

[NutAce]

You can find this in the Customer Defaults under Assemblies - Site Standards - Tab Reference Sets - Model Reference Set.

Set it to No Automation. (this can be blocked by your site admin)


Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11

 

[flitch1969]

thank you.