Ref.dimension display problem in SW2003

[ssizz]

Hi, all
I'm new on solidworks, and I'm using solidworks2003. I have a curious problem in solidworks derawings. I used to use reference dimension instead of insert dimension from the model. But all the dimensions I got always have a "RD#" below the numbers where # are numbers set by SW itself. I checked the help files and I can not find a way to remove it. Do anyone know how to do this?
Thanks in advance.

 

[MechEng13]

There is a setting in the tools menu, that allows you to turn off the display of dimension names. For the "RD#" to show you have this setting set to on.

I can't give you the exact location as I have been away from SWX for 5 months now.

HTH,


Alan M. Etzkorn
Product Engineer
Nixon Tool Co.

http://www.nixontool.com

 

[DHALE1]

The setting is under the general tab in system options. The third checkbox down is Show dimension names, leave that unchecked.

 

[ssizz]

Thank you guys very much, I finally can get ride of these "dimension Names".