Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Red marking drawings within Pro/E

Status
Not open for further replies.
CheckerRon

CheckerRon

Mechanical
Jun 20, 2006
368
Heckler, TheTick, and any other Pro/E Wildfire guys out there. Please check out my post on the Enginering Computer Programs PTC ProEngineer thread. Any thoughts / comments?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Got my answer on the CAD thread. File>New>markup

Ron
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

dthom0425
  • Question
Specifying ASME versions on drawings
Replies
4
Views
2K
supergee
supergee
Rayleigh
  • Locked
  • Question
Fraction in Decimals within drawing. 7
2 3
Replies
50
Views
2K
Mech1595
Mech1595
Michael_Michael_Motorcycle
  • Locked
  • Question
Incoming Inspection Details on Drawings 1
2
Replies
27
Views
1K
Garland23
Garland23
Jupshaw
  • Locked
  • Question
Request for Recommended Approaches for Determining Projection Type in Engineering Drawings 2
2
Replies
25
Views
753
3DDave
3DDave
FrancoisY
  • Locked
  • Question
Family Drawings Revision Help
Replies
10
Views
495
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top Bottom