Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Rectangles in Hole Tables
- Thread starter Pachem
- Start date
CorBlimeyLimey
Mechanical
To select the holes for the table, I assume you picked the face which has the holes in it? If so, the only way I know, is to delete the row in the table which references the rectangular hole. (RMB a cell in that row > Delete > Row)
If you select the holes individually, obviously you can omit the rectangle (loop) & it will not show in the table. This is OK for small quantities of holes, but would be a pain if there were many.
Anyone else know of other ways?
![[cheers]](/data/assets/smilies/cheers.gif "[cheers] [cheers]")
from Barrie, Ontario.
![[lol]](/data/assets/smilies/lol.gif "[lol] [lol]")
For Sale: Parachute. Only used once, never opened, small stain
faq559-863
If you select the holes individually, obviously you can omit the rectangle (loop) & it will not show in the table. This is OK for small quantities of holes, but would be a pain if there were many.
Anyone else know of other ways?
from Barrie, Ontario. For Sale: Parachute. Only used once, never opened, small stain faq559-863
- Status
Similar threads
- Question
- Locked
- Question