Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recommended torque values for rubber lined Piping?

Status
Not open for further replies.
oloweider

oloweider

Mechanical
Joined
Sep 30, 2013
Messages
1
Location
CA
Does anyone have a recommended torque values for rubber lined Piping? The lining is neoprene on regular CS pipng.The actual rubber lining extend over the flat face gasket area so no gaskets are required.
 
Sort by date Sort by votes
oloweider,
You should ONLY take the advice of the Vendor providing your Neoprene Liner! Doing anything else could void your warranty.

prognosis: Lead or Lag
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

M
  • Locked
Piping for N2
Replies
5
Views
6K
georgeverghese
georgeverghese
jafary64
  • Question Question
Hot Dip or Cold Galvanized for Stud bolt in Piping
Replies
14
Views
6K
MintJulep
M
StressGuy
  • Question Question
Straight run for vertical pump suction piping?
Replies
5
Views
4K
StressGuy
StressGuy
D
  • Question Question
Closed Loop Piping-Vacuum Issue
Replies
10
Views
8K
georgeverghese
georgeverghese
mariolucas75
  • Locked
  • Question Question
Temporary Repair calculations for piping
Replies
7
Views
6K
HTURKAK
HTURKAK

Part and Inventory Search

Sponsor

Back
Top