Could anyone help, I have a question regarding the installation of Screwed and Socket-welded Unions. I have ran across some unions installed wrong. I can't find anything documenting that the nut should be on the flow side, I know this is probably "rule of thumb". Can anyone point me in the direction to find documents supporting this. Thanks in advance for any help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recommended Installation
- Thread starter moseley
- Start date
Similar threads
- Locked
- Question
- Locked
- Question