SolidCreative
Mechanical
I want to use cosmos motion for a reach study using a 6 axis robot. I would like to be able to use the face plate of the robot and have it follow a set of sketch lines. Is this possible?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Reach Study
- Thread starter SolidCreative
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question