Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
RBE2 Rigids
- Thread starter bdidle
- Start date
BlasMolero
Mechanical
Dear Bdidle,
In "Nastran Output Request" make sure to activate "Force Balance" (please note is OFF by default). Run your analysis. Go to F5, activate DEFORM & CONTOUR, click on DEFORM & CONTOUR DATA, select the Output set, the Output vectors & contour you like, and click on FREE BODY DISPLAY, here is where you are allowed to plot everything like reaction loads, multipoint reaction loads, etc.. You will need to create a group with the nodes where you want all that stuff data -- good luck!!.
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48011 BILBAO (SPAIN)
WEB:
In "Nastran Output Request" make sure to activate "Force Balance" (please note is OFF by default). Run your analysis. Go to F5, activate DEFORM & CONTOUR, click on DEFORM & CONTOUR DATA, select the Output set, the Output vectors & contour you like, and click on FREE BODY DISPLAY, here is where you are allowed to plot everything like reaction loads, multipoint reaction loads, etc.. You will need to create a group with the nodes where you want all that stuff data -- good luck!!.
Best regards,
Blas.
~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director
IBERISA
48011 BILBAO (SPAIN)
WEB:
- Status
Similar threads
- Locked
- Question