Hey all,
I'm wondering if any of you have experience with anything that can seal a shaft travelling at around 3000rpm but also must allow +/-10mm axial shaft movement?
Originally I was going to use a basic radial lip seal but I'm not sure if the lip will just bend back on its self when the shaft is axially moved.
Cheers
Steve
I'm wondering if any of you have experience with anything that can seal a shaft travelling at around 3000rpm but also must allow +/-10mm axial shaft movement?
Originally I was going to use a basic radial lip seal but I'm not sure if the lip will just bend back on its self when the shaft is axially moved.
Cheers
Steve