Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"Fittings" Pressure Losses in Channels

Status
Not open for further replies.
shahyar

shahyar

Chemical
Joined
Feb 15, 2005
Messages
216
Location
CA
Do we have "equivalent Length" or K-factor for pressure loss calculations in elbows and U-turns in Channels (canals),something that we have in pipes?

Thanks for replies.
 
Status
Not open for further replies.

Similar threads

NW_Wash_Eng
  • Locked
  • Question Question
Dynamic and Static Thrust Forces - What is considered "Problematic"
Replies
15
Views
2K
NW_Wash_Eng
NW_Wash_Eng
Adam1900
  • Locked
  • Question Question
Potable Water Pipe Valves Fittings Protection in Fillcrete Backfill
Replies
3
Views
1K
bimr
bimr
kwisatz_haderach
  • Question Question
Dual Media filter vs Pressure sand filter
Replies
12
Views
6K
bimr
bimr
TXPE_MED
  • Locked
  • Question Question
Horizontal and Vertical Conventional Pressure Tanks in same plant?
Replies
4
Views
1K
1503-44
1503-44
jwsutto
  • Locked
  • Question Question
Pressure tanks in village scale potable water distribution systems?
Replies
6
Views
928
bimr
bimr

Part and Inventory Search

Sponsor

Back
Top