Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"Fittings" Pressure Losses in Channels

Status
Not open for further replies.
shahyar

shahyar

Chemical
Feb 15, 2005
216
Do we have "equivalent Length" or K-factor for pressure loss calculations in elbows and U-turns in Channels (canals),something that we have in pipes?

Thanks for replies.
 
Status
Not open for further replies.

Similar threads

NW_Wash_Eng
  • Locked
  • Question
Dynamic and Static Thrust Forces - What is considered "Problematic"
Replies
15
Views
1K
NW_Wash_Eng
NW_Wash_Eng
Adam1900
  • Locked
  • Question
Potable Water Pipe Valves Fittings Protection in Fillcrete Backfill
Replies
3
Views
1K
bimr
bimr
TXPE_MED
  • Locked
  • Question
Horizontal and Vertical Conventional Pressure Tanks in same plant? 1
Replies
4
Views
1K
1503-44
1503-44
jwsutto
  • Locked
  • Question
Pressure tanks in village scale potable water distribution systems? 1
Replies
6
Views
640
bimr
bimr
michaeljack88
  • Locked
  • Question
Hydraulic Design - Break Pressure Tank 1
Replies
17
Views
2K
katmar
katmar

Part and Inventory Search

Sponsor

Back
Top Bottom