musclehead
Mechanical
I HAVE A PART I SPLIT WITH COMPLEX SURFACE. NOW I AM TRYING TO PLACE FILLET ON PART EGDES AFTER A SHELL. THE FILLETS WORK ON JUST A FEW EDGES. DOES ANYONE HAVE SUGGESTIONS.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
PUTTING A FILLET ON EDGE?
- Thread starter musclehead
- Start date
- Status
lordrailie
Marine/Ocean
Is there any possibility of confusion for the path that the fillet has to follow??? if so, you might have to select the edges you want to keep.
It happend to me sometimes when i want to create a fillet over an edge that in a point is tangent to two other edges and the software doesn't know where to go, so I just have to select the edge I want to fillet and the one i want to keep.
It happend to me sometimes when i want to create a fillet over an edge that in a point is tangent to two other edges and the software doesn't know where to go, so I just have to select the edge I want to fillet and the one i want to keep.
- Status
Similar threads
- Locked
- Question
