Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating a pad on inclined side surfaces

Status
Not open for further replies.

Eisengrindt

Automotive
Aug 8, 2024
1
DE
Hello together!

Is there any chance for creating a pad / thickening a surface with more than one directions? The desired profile is shown here by the white line.

Bild5_vogofx.jpg


Basically like the thickness command, but without moving the mentioned edge.

Thank you very much!
 
Replies continue below

Recommended for you

It's been a while since I've used it, but I think the multi-section solid tool (or maybe it's the loft tool?) should be able to do what you want.
 
Yes, Multi section solid is the way here.
You will need the end plane/end sketch for it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top