Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pulling datum targets in from model to draft

Thread starter KENAT
Start date Jul 16, 2008

Status: Not open for further replies.

Jul 16, 2008

KENAT

Mechanical

I've put my datum targets in sketches in the relevant orientation in the model.

I do retrieve dimensions in the draft to pull them in. Some of them come in OK but several of them came through in the wrong place.

Any ideas?

V19

KENAT, probably the least qualified checker you'll ever meet...