Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PS text not showing up over viewport when a raster image is in model space.

Thread starter kc27315
Start date Jun 30, 2017

Status: Not open for further replies.

Jun 30, 2017

kc27315

Civil/Environmental

thread555-88205

I have had the most difficult time getting some PS text in a particular dwg to show up over a viewport that has a raster image. Tried multiple workarounds with no luck. Finally, a coworker suggested I do an audit on the dwg, then save, close, and re-open. For some reason it did the trick! Just wanted to share with others that may be having the same problem.