Hello! I am new to Draftsight. I have been studying the lessons and have run into a problem. I am not sure if this forum is where I should be asking this question. If it is inappropriate I am sorry. But, here goes. In Lesson 3 at nearly the end, it says to scroll to the "Tolerance section" in the "Properties manager palette". I have searched the palette thoroughly and cannot locate a Tolerance section. Any advice on what is wrong? Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Properties box 1
- Thread starter sheriff12
- Start date
-
1
- #2
CorBlimeyLimey
Mechanical
Did you have a dimension selected when searching the Properties Manager?
The Tolerance section is near the bottom of the manager.
The Tolerance section is near the bottom of the manager.
- Status
Similar threads
- Locked
- Question