Hello all I am new here but I hope you can help. First off I am well aware that what I am trying to do here is a bad situation already. I have a hex nut with 6 projections .4mm tall that I am trying to weld to 1.6mm thick HSLA. Any suggestions on the parameters to use for this would be really helpful. Thanks Mike.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Projection welding with HSLA and incorrect nut
- Thread starter rebelxug
- Start date
Similar threads
- Locked
- Question
