Profile Tolerance per Y14.45 2021

[DJ Nelson]

Reporting A Unequal Surface Profile Tolerance per Y14.45 2021 in PC-dmis we not sure if the results are correct versus the calculation in the measurement standard. In PC-dims it reports the profile as being out of tolerance by .006 the point that deviate's the most are in the positive direction by .008 PC-dims seems to double that deviation. I believe that .008 would be the G X 2 = .016 + .01 = .026 OOT by .016 The same calculation seems to work for a Equal tolerance zone or you could double the .008 for .016 as your Profile see attachment for the CMM results and the outside the tolerance results.

 

[3DDave]

Is it PC-DMIS?
There is no attachment.

For engineering or to diagnose a fit problem, Y14.45 gives zero or even negative useful information, so I have a blind-spot.

If you add the attachment I can try to compare it to the Y14.45 method.

 

[DJ Nelson]

I keep getting a error when attaching a file with the problem+
+
Oops! We ran into some problems.

 

[3DDave]

What file type is being attached and can you just use the image button instead?

 

[DJ Nelson]

I tried a .jpg and an .png

 

[3DDave]

When you use the image button what happens? (also available by ctrl-P) Do you have javascript disabled?

 

[DJ Nelson]

3DDave
I keep getting a error when attaching a file with the problem+

"Oops! We ran into some problems."

I may be on our end we keep getting the same error

 

[3DDave]

Do you have javascript disabled:

YES [_] - If yes, then enable javascript

NO [_] - hmmm.

What browser? What OS? Perhaps move the file to a local folder?

Did you use ctrl-p? Did "drop image" appear?

Are you trying "Attach files" instead of Insert Image?

 

[DJ Nelson]

3DDave
I keep getting a error when attaching a file with the problem+

"Oops! We ran into some problems."

I may be on our end we keep getting the same error+

3D Dave I tried it from home it works have to see what's going on with the work computer

Reporting A Unequal Surface Profile Tolerance per Y14.45 2021 in PC-dmis we not sure if the results are correct versus the calculation in the measurement standard.
In PC-dims it reports the profile as being out of tolerance by .006
the point that deviate's the most are in the positive direction by .008 PC-dims seems to double that deviation.
I believe that .008 would be the G X 2 = .016 + .01 = .026 OOT by .016
The same calculation seems to work for a Equal tolerance zone or you could double the .008 for .016 as your Profile
see attachment for the CMM results and the outside the tolerance results.