Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ProE and Sigmetrix
- Thread starter aogburn1
- Start date
Usng the Sigmetrix modules will give you a report on how the tolerances on individual parts could interfere or become too large of a gap at the assembly level. It basically takes the parts and runs them through their tolerance limits in conjunction with your other components.
It does take some training to understand the system and consistent use to hone your skills. The analysis set up in Sigmetrix also takes some time, but may be better now, since I haven't used it since WF1 in 2005.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
It does take some training to understand the system and consistent use to hone your skills. The analysis set up in Sigmetrix also takes some time, but may be better now, since I haven't used it since WF1 in 2005.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
- Status
Similar threads
- Locked
- Question
- Locked
- Question