Hi,
I carry out the dynamic analysis of a pair spiral bevel gear with Dytran. I made the design with Catia ana I have imported good this geometry.
I have applied the mesh (teth4), load and the boundary condition, with the firs five tooht contact. Also, I have applied the material.
When I run Dytran, Dytran sent me the next error message:
%E-P2109904-P2XXTXIX_PACKET_FORCE0,,,
The FORCE vector on FORCE entry 10 has 3 zero components.
Please check your input data.
NO MORE MESSAGES OF THIS KIND WILL BE WRITTEN
I carry out the dynamic analysis of a pair spiral bevel gear with Dytran. I made the design with Catia ana I have imported good this geometry.
I have applied the mesh (teth4), load and the boundary condition, with the firs five tooht contact. Also, I have applied the material.
When I run Dytran, Dytran sent me the next error message:
%E-P2109904-P2XXTXIX_PACKET_FORCE0,,,
The FORCE vector on FORCE entry 10 has 3 zero components.
Please check your input data.
NO MORE MESSAGES OF THIS KIND WILL BE WRITTEN
