Pro Mechanica Installation

[camilia]

Hej alla
I am a beginner with pro mechanica ... I have a problem with pro mechanica installation as ... after making geometry of my structure I switch to application, mechanica mode and define material, assign material, define bc, forces do the meshing ... but when I run analysis it says some thing strange """"Pro Mechanica needs to be installed """" well I have defined all these steps in mechanica (I guess) .... then what mechanica needs to be installed?
can any 1 help me out this problem?
Mvh

 

[solidworm]

Pro Mechanica has two modes, FEM and full. FEM mode only allows you to define geometry, loading,constraints and i guess meshing too.then you have to do the analysis step using other solvers like ansys and etc.in other words, FEM mode is only a pre-processor. you probably have set it up in it this mode, or you don't have the required mechanica license.




Edited by: solidworm

 

[camilia]

...Yeah I dont have full mode then ... Tack s