Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/Mechanica Database ID Numbers

  • Thread starter Thread starter brow0695
  • Start date Start date
Status
Not open for further replies.
B

brow0695

Guest
I keep getting an error stating that my model is insufficiently constrained. This message is followed by two numbers that are Pro/Mechanica Database ID Numbers. What are these and where can find them. Better yet can anyone tell me why my model is insufficiently constrained. I am using the Independent mode Pro/Mechanica. My model is constructed of beam elements with various beam sections.
 
Status
Not open for further replies.

Similar threads

jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
801
jasongBSME
jasongBSME
T
Pro mechanica - create a mesh from imported points (nodes)
Replies
1
Views
24K
Twig Studio
T
A
Pro/Mechanica Material Assignment and Meshing for Assemblies
Replies
0
Views
6K
AMega
A
woofer54
  • Locked
  • Question Question
Pro E Wildfire 5.0 Mechanism Flexible Simulation
Replies
0
Views
705
woofer54
woofer54
Tmoose
  • Locked
  • Question Question
Borrowing Mechanica license
Replies
0
Views
201
Tmoose
Tmoose

Part and Inventory Search

Sponsor

Back
Top