Does anyone know if there is a library of Pro/Engineer generated springs available or has someone developed a program ?? I have been creating simple springs using 'Create.. Protrusion.. Advanced .. Helical Sweep.' commands but the final result isn't very good (ie, if the ends need to be gound square or closed, etc). I could create curves etc but I believe that there must be another way......
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pro/Engineer: Producing Springs 2
- Thread starter Haym
- Start date
-
2
- #2
helpmewithintralink
Automotive
Springs, as simple as they are, are tough to model.The complexity depends on how you want the model to change in your assembly. There are lots of free models out there.
You may not get what you want.
Here is a link you can try:
You may not get what you want.
Here is a link you can try:
helpmewithintralink
Automotive
you can also try ( someting like that )
- Status
Similar threads
- Locked
- Helpful tip