Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pressure gauge relief design

Status
Not open for further replies.
joker6

joker6

Mechanical
Joined
May 17, 2010
Messages
1
Location
US
For a pressure gauge measuring steam at 328 def F, 270 psig, is there any advantage to using blowout back over blowout disc? It seems that blowout back would provide more safety but I cannot verify it in any manufacturer's literature.
 
Status
Not open for further replies.

Similar threads

Channo
  • Locked
  • Question Question
Spring Adjustment in Pressure relief valve
Replies
6
Views
1K
Channo
Channo
Shafty1
  • Question Question
pipe clamp design
Replies
7
Views
6K
Stress_Eng
Stress_Eng
Mech 3D
  • Locked
Design
Replies
9
Views
3K
BEMPE16524
BEMPE16524
A
  • Question Question
Connector to casing assembly design
Replies
7
Views
4K
drawoh
drawoh
mr_abbasi
  • Locked
  • Question Question
Lift design
Replies
2
Views
3K
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top