Post Processor For Fanuc 0M

[qasim]

This is My first Massege. I have a CNC Machining center with fonuc 0M board. i need post processor file for PorE2. can any one help me .


thanks is advanced

 

[ctarmijo]

Good Morning qasim,


There are a few topics concerning post processors in this forum but if you are new to ProMan, then there are some post processors you can download from the PTC website. You will need a current maintenance agreement to gain access to the posts. There you will find a post processor for a FANUC controller that you can start with. After that, you will need to make changes to the post to fit your needs. Good luck!


Christopher

 

[qasim]

what was the link for ptc post processor

 

[ctarmijo]

Here you go...


http://www.ptc.com/cs/cs_23/howto/ncgp4903/ncgp4903.htm


Good luck!


Christopher

 

[Niteen]

Even if you have the software of pro e u can have the post from the software itself its in the opt file hidden. Just tryout third option while selecting post & the from ther u can get the post its in ur computer itself. try I did it myself so u can too . Its long back I did but u can too.


niteenparwal@hotmail.com


India


u can contact me by mails