Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Position of an Out- and Inputport

Status
Not open for further replies.
Phaneas

Phaneas

Mechanical
Joined
May 17, 2005
Messages
38
Location
EU
Hello, i want to create a subsystem-block, which has an input- and an outputport at the upper side, and an input- and an outputport at the left side.
Does anybody know a command to define the position of out- and inputports ?
 
Status
Not open for further replies.

Similar threads

RDEEE
  • Locked
  • Question Question
Microwave signal source and directional coupler
Replies
0
Views
697
RDEEE
RDEEE
Lyapunov23
  • Locked
  • Question Question
interactions among simulink and mySql
Replies
0
Views
736
Lyapunov23
Lyapunov23
peppe89
  • Locked
  • Question Question
switch and PID controller
Replies
0
Views
819
peppe89
peppe89
chfakht
  • Locked
  • Question Question
Modeling accelerometer and gyroscope in simulink
Replies
4
Views
1K
chfakht
chfakht
omareladel
  • Locked
  • Question Question
Modeling of a wheel on Simmechanics
Replies
4
Views
451
omareladel
omareladel

Part and Inventory Search

Sponsor

Back
Top