PMI Hole Call Out in Assembly?

[Matsa]

Hi,
Is it possible to create PMI Hole Callout on a part in a assembly? I am using Hole command with Type threaded hole on my piece part.
I have not the ability to select the feature Threaded hole with method Hole callout. I have my part fully loaded and Exact, selection scope to Entire Assembly.

And when I am using method inferred I can select Threaded hole feature, but I get error message "Annotation Plane definition conflicts with selected geometry".

See attached models. I am using NX9

Thanks in advance

 

[kapmnit123]

Hi Matsa,
I think not yet. But you can always put PMI Hole Call on the part itself and then make it appear in Assembly (using ASSEMBLY PMI FILTERS).
Attached is an image.
Regards
Kapil

 

[Matsa]

Hi, and thanks for your response..
I will try that method.

Thanks / Matsa

 

[kapmnit123]

i have attached an avi also..
Regards
Kapil