Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plug Weld Diameter

Thread starter BodyBagger
Start date Nov 3, 2010

Status: Not open for further replies.

Nov 3, 2010

BodyBagger

Mechanical

Hello all,

1st post in this forum.

I was wondering if there is a standard or similar that determines the hole diamter for doing plug welds. For example, if I need to plug weld two 12awg plates together what dimater should be drilled in the top plate?

Thanks for any input.
BB