PLS CADD

[ekieder]

Hello

I´ve just started to work with PLS CADD, I´m having a little bit of trouble, and I´d be really grateful if someone could give me a hand.
I have got cartography, towers´ models, described extra-cost & prohibited zones and already defined criteria
and now I´m trying to use Optimum Spotting. We are simulating a double circuit line but when I run simulation
I can just get a simple circuit, no fibre line and no grounding cable.
What am I doing wrong? Because to simulate optimum spotting assigning differents towers it has got to take into
account 2 circuit and fibre´s forces. Hasn´t it?


Thanks a lot

 

[ekieder]

Thanks once again Transmission Towers
I contact PLS Support three times a weeek
but they normally send me to read their webpage
where they use PLS CADD/Lite and PLS Pole and have an
example of a wooden pole which it´s "quite" less complicated than
a double circuit 400 kV Tower. I guess they are not very collaborative
because of the training classes.

Thanks a lot

You are one of the "indispensable ones"