Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
plotting in nx3
- Thread starter EngMfg1
- Start date
goto the internal UG bbsnotes board. It has been explained in great detail over there.
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
- Thread starter
- #3
You'll need a valid Webkey account to access the bbsnotes page. If you don't know what I'm talking about, then I'd suggest calling GTAC support at 800-955-0000 & getting some help from them.
Here's the link to the GTAC website:
The link to bbsnotes is on the left side of that page....might have to look for newsgroups or something like that.
Tim Flater
Senior Designer
Enkei America, Inc.
Here's the link to the GTAC website:
The link to bbsnotes is on the left side of that page....might have to look for newsgroups or something like that.
Tim Flater
Senior Designer
Enkei America, Inc.
- Status
