For solidedge v.20 (for st3 is the same) how can you make a customization so that a copy of the mass field in a solidedge part file (.psm, .prt) found at inspect- physical properties – mass to be available automatically updated in file- file properties – custom in a custom field called mass?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
place copy of mass field to file properties
- Thread starter alpar79
- Start date
beachcomber
Mechanical
I think one of the problems could be in using pdmworks.
Surely that's intended for SolidWorks not Solid Edge, and if it doesn't do what you want it to you should contact the people who sold it to you.
Can't you use the free SolidEdge viewer?
Can't pdmworks handle pdf files?
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
Surely that's intended for SolidWorks not Solid Edge, and if it doesn't do what you want it to you should contact the people who sold it to you.
Can't you use the free SolidEdge viewer?
Can't pdmworks handle pdf files?
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
- Thread starter
- #22
- Status
Similar threads
- Locked
- Question
- Locked
- Question