Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Piping Specs for High Pressure Gas Injection

Status
Not open for further replies.
jcbb47

jcbb47

Mechanical
Joined
Jun 18, 2002
Messages
6
Location
US
Hi.

May be someone has got experience about this case...I hope so...!

My question:

Should I design by ASME/ANSI B31.3 or ASME/ANSI B31.8 in a High Pressure Gas Injection pipeline (Design Pressure = 9000 PSIA / Length = 12 Km) ?

 
Sort by date Sort by votes
Hi there,

What is the size of this pipeline?

YONG HEE KIM
 
Upvote 0 Downvote
Hi, thanks for your interest.

Pipeline estimated size is 12.75 OD. Thickness will depend on which one code is gonna be used.

What do you think ?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Adnan.B
  • Locked
  • Question Question
Frame 5 Gas Turbine trips on high combustion temperature
Replies
3
Views
3K
LittleInch
LittleInch
Alice24
  • Locked
  • Question Question
Solution for small pressure for X seconds then high pressure for X seconds operate bistable cylinder
Replies
1
Views
815
1503-44
1503-44
YungPlantEng
  • Locked
  • Question Question
Cost effective methods to prevent significant pressure losses for compressed air from heavy users?
Replies
4
Views
3K
georgeverghese
georgeverghese
BenGreenhalgh
  • Locked
  • Question Question
Pressure Increase
Replies
13
Views
2K
BenGreenhalgh
BenGreenhalgh
MADHU MADATHIL
  • Locked
  • Question Question
Argon Gas requirement
Replies
11
Views
2K
1503-44
1503-44

Part and Inventory Search

Sponsor

Back
Top