Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Piping Parallelism

Thread starter jhampton1970
Start date Jul 12, 2006

Status: Not open for further replies.

Jul 12, 2006

jhampton1970

Mechanical

Does anyone know where to find an ASME code or another reference concerning piping parallelism? Recently, I have started a career with a new company, which is quite young. Their documentation is still in the growing process. The last company I worked for had a test certificate, which stated 0.40mm per every 100mm of piping OD. Is this a general standard, or just that company's policy?

Regards,
Jason Hampton
-Freedom isn't free!