Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pipe feature dispaly

  • Thread starter Thread starter doowop1
  • Start date Start date
Status
Not open for further replies.
D

doowop1

Guest
I have modeled several pipes using the pipe feature and datum points. I'm getting a feature has been successfully created message but the pipe is not showing. The centerline is showing. What's the problem? I imagine it's some config setting.
 
Status
Not open for further replies.

Similar threads

PhilKa
  • Locked
  • Question Question
Creo Macro for Supressing Features
Replies
1
Views
481
3DDave
3DDave
Korichnevijgigant
  • Locked
  • Question Question
Feature X breaks group with Feature XXX error
Replies
1
Views
754
Korichnevijgigant
Korichnevijgigant
Fernandoomi
  • Locked
  • Question Question
How to change Pipe segment Diameter? (CREO 4.0)
Replies
1
Views
413
3DDave
3DDave
jzecha
  • Locked
  • Question Question
Copy Features Without References
Replies
2
Views
468
peppinu
peppinu
treddie
  • Locked
  • Question Question
How to get analysis measurement feature into a relation
Replies
2
Views
384
TiagoFigueiredo
TiagoFigueiredo

Part and Inventory Search

Sponsor

Back
Top