Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Phase angle in SAP2000

Thread starter easap
Start date Jul 30, 2013

Status: Not open for further replies.

Jul 30, 2013

easap

Civil/Environmental

Hi guys

Is it possible to change the phase angle of a load that is defined as a time history sine function. I can't find it anywhere, the "angle" in "load case data - linear modal history" doesn't quite do the trick.

I want to use the time history function for multiple loads and it would help a lot if I could specify the phase angles without having to define a new function for each load..