Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
pattern sketch elements???
- Thread starter skeeter83
- Start date
skeeter,
What exactly are trying to do? Without a base feature like a protrusion or surface you can create the pattern points, but will be unable to pattern the circle itself. If you have a base feature, then there are a couple ways to accomplish the actual patterning.
Do you have a drawing or screenshot that you can post so we can see what exactly your trying to do??
Jason
What exactly are trying to do? Without a base feature like a protrusion or surface you can create the pattern points, but will be unable to pattern the circle itself. If you have a base feature, then there are a couple ways to accomplish the actual patterning.
Do you have a drawing or screenshot that you can post so we can see what exactly your trying to do??
Jason
In Draft, yes you can make non-associative patterns of elements.
In model sketches, no you cannot make patterns of 2D elements.
Ken G.
In model sketches, no you cannot make patterns of 2D elements.
Ken G.
- Thread starter
- #4
- Status
Similar threads
