partial variable radius on an edge

[olivierpa]

Hello heverybody


I have a new problem , I have to creat a variable radius on an edge


on PNT8 , R=0 , on PNT6 R=1.5 , on PNT4 R=4.1 , on PNT2 R=8.1 and on PNT9 R=0








If one of you have an idea to made the job , it will be great


Olivier

 

[sanjeevkar1]

UPLOAD THE PART PLEASE

 

[olivierpa]

Hello Sanjeevkar1


here attache the file


2009-09-04_043930_propeller_shaft_g4.prt.zip


Thank


Olivier

 

[anand_m_s]

Hi Olivier,


Look at this snapshot below:





Is this what you are expecting? I did this feature using VSS. I do not think that simple Fillet with variable radius will serve the purpose.


Regards,


Anand

 

[olivierpa]

Dear Anand


Sorry it's not what I need , in fact I have to round the key groove as requested by classification societies, following the document attache( it's in french but you have all the formulas)








Thank for your help


Olivier

 

[kdem]

You may be able to get close but not exact with variable rounds. Here is what I came up with. Is this something similar?





Not sure I'd say this is the way to go though.