Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Part number suffix for Parker wear rings?

Status
Not open for further replies.
CamoColton

CamoColton

Mechanical
Joined
Oct 13, 2008
Messages
4
Location
US
I'm making an ordering standard again for my company and can't determine the correct suffix for Parker WPT wear ring part numbers to specify an angle cut. I think it is either "$KIV" or "$TEP". Parker is of no help. Does anyone have any experience ordering or specify these rings?

Any insight is appreciated.
 
Status
Not open for further replies.

Similar threads

Faustie
  • Locked
  • Question Question
Possible to have non-circular radial seal for o-rings?
Replies
5
Views
2K
lucky-guesser
lucky-guesser
innominata
  • Locked
  • Question Question
Smallest O Ring Cross Section for Face Seals - Parker O Ring Handbook
Replies
7
Views
1K
Prometheus21
Prometheus21
65CCJ
  • Question Question
480 Mpa (69,620 psi) static seal for hydrotesting at Room Temp.
Replies
0
Views
7K
65CCJ
65CCJ
F
  • Locked
  • Question Question
Automatic Top up unit for plan 53b
Replies
3
Views
3K
georgeverghese
georgeverghese
J
  • Question Question
Rod & Bore Diameters For 112 Quad Ring + Rod Bore Clearance
Replies
0
Views
1K
JBartlett61
J

Part and Inventory Search

Sponsor

Back
Top