Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Part number suffix for Parker wear rings?

Thread starter CamoColton
Start date Aug 19, 2009

Status: Not open for further replies.

Aug 19, 2009

CamoColton

Mechanical

I'm making an ordering standard again for my company and can't determine the correct suffix for Parker WPT wear ring part numbers to specify an angle cut. I think it is either "$KIV" or "$TEP". Parker is of no help. Does anyone have any experience ordering or specify these rings?

Any insight is appreciated.