Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Part jumping in Mechanism

  • Thread starter Thread starter fredws
  • Start date Start date
Status
Not open for further replies.
F

fredws

Guest
I am creating an assembly, putting a hydraulic cylinder on a mount. Used a pin connection, and everything appears correct. However, when I go to Mechanism to rotate the cylinder, the cylinder jumps over. What am I doing wrong here?



TIA!
 
if it possible email me your file
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top