Hello everyone,
I am driving myself crazy trying to figure out how to assign tolerances in the parameter table. I have the dimension, name, etc, and I can tell Inventor how to display the part (min, max, middle of tolernace). However, I need to easily define tolerances (ie without right clicking the dim and choosing "tolerances
. The ultimate goal is to create iFeatures that have varying tolerances based on feature size, thus the need for a column for the min and max tolerance.
I do not care if I do this in the part parameter table, or when editing the iFeature and creating different variations as long as I can make it happen. Any ideas?
BTW, I am running 2008 Pro.
Thanks!
I am driving myself crazy trying to figure out how to assign tolerances in the parameter table. I have the dimension, name, etc, and I can tell Inventor how to display the part (min, max, middle of tolernace). However, I need to easily define tolerances (ie without right clicking the dim and choosing "tolerances
. The ultimate goal is to create iFeatures that have varying tolerances based on feature size, thus the need for a column for the min and max tolerance.I do not care if I do this in the part parameter table, or when editing the iFeature and creating different variations as long as I can make it happen. Any ideas?
BTW, I am running 2008 Pro.
Thanks!
